The use of AB glue dispenser usually involves multiple steps, and the following is a detailed introduction:

Preparation work:
1.Ensure that all parts of the AB glue dispenser are intact, without loosening or damage.
2.Check whether external conditions such as the air source and power supply meet the requirements of the device.
3.The A glue and B glue are respectively loaded into the A bucket and B bucket of the AB glue dispenser, and pay attention to distinguish the color and label of the two kinds of glue to avoid confusion.
4.Make sure the rubber drum is well sealed to prevent glue leakage.
5.Connect the rubber hose of A and B rubber to the mixing pipe to ensure that the connection is tight without leakage.
6.According to the mixing ratio of AB glue used, adjust the proportion controller of AB glue dispenser.
Set parameters:
1.According to product requirements and process requirements, set the dispensing amount of AB glue dispenser. This can be achieved by adjusting the opening of the dispensing valve, the size of the air pressure or the time control.
2.If the AB glue dispenser is equipped with auxiliary equipment such as a visual positioning system or a robot, it is also necessary to set the fixed glue path and trajectory. This usually involves entering information such as the size, shape and dispensing position of the product into the software and then generating the corresponding dispensing path.

Start device:

1.Connect the power and air supply of AB glue dispenser, and start the equipment according to the requirements of the equipment manual.
2.Pay attention to check whether the equipment is running normally. If there is abnormal sound or vibration, stop the machine immediately.

Start dispensing:

1.Place the product that needs to be dispensed on the work table of the AB glue dispenser, and fix the position to prevent movement.
2.If the device is equipped with a positioning clamp, the product should be placed in the clamp and locked.
3.Start the dispensing process, AB dispensing machine will start dispensing according to the set parameters and path.
4.In the dispensing process, the operator should pay close attention to the operation of the equipment to ensure that the dispensing quality meets the requirements.

End and clean up:

1.After dispensing is complete, close the AB dispensing machine according to the requirements of the equipment manual. Pay attention to close the dispensing process before closing the power and air supply to protect the equipment.
2.Clean the residual glue on the rubber bucket, mixing tube, dispensing valve and other parts of the AB glue dispenser. You can use appropriate cleaning agent or solvent to clean the equipment to ensure that there is no residue.
3.Check the parts of the equipment regularly for wear or damage, and replace or repair in time if necessary.